Skip to main content
To KTH's start page

Refurbishment Strategy Based on Smart Radiator Controllers

Background

Buildings use approximately one third of the overall energy use in developed countries. In the last decades, the energy use in newly constructed buildings has been significantly decreased by stricter regulation requirements and improvements in design and building energy and control systems. Still, in older buildings there is an urgent need for cost-efficient solutions capable to optimize energy use and indoor comfort.

Solutions based on digitalization have proven to be cost effective in optimizing the operation of residential buildings. This thesis deals with a refurbishment strategy based on smart radiators controllers; in particular, the thesis focuses on its implementation feasibility on an existing block of flats representative of older residential buildings in Stockholm.

This thesis is a collaboration between JLW Fastigheter, KTH Department of Energy Technology and the KTH Live-In Lab . The thesis is supported by the Swedish Energy Agency as part of the DOCENT  project; this research aims to develop and implement cost-effective, practical, and scalable solutions for the Nordic countries.

Experimental setup

The property used for the experimental setup is located on Valhallavägen close to KTH main campus. The property was constructed 1931 and comprises 30 residential units, three retail spaces and a garage facility.

All apartments in the building feature temperature and humidity sensors which are used to centrally control the heating system and provide an average indoor temperature of 20˚C.  

Nevertheless, following the complaints of some tenants on thermal discomfort in winter 2022, an investigation was carried out. Preliminary results from the analysis of the indoor climate conditions reached the following conclusions:​

  • some complaining tenants have lower temperatures than other residents, while one of the residents that complained had over 21˚C;

  • the apartments with the lowest temperatures are around 18˚C, while the apartments with the highest temperatures are up to 24˚C;​

  • there is no intuitive pattern explaining the uneven distribution of temperatures among the apartments; for instance, some of the coldest are apartments are located both on the highest floor and lowest floor. ​

Research challenges and main objectives

The work in this thesis will:

  • Extend the analysis of the indoor and energy data available to identify anomalous temperature patterns in the apartments;

  • Estimate the energy overshoot and comfort due to the power imbalance in the system;

  • Assess the potential energy savings from a fine tuned system;

  • Identify reliable and cost-efficient smart thermostats to improve the radiator control.

Perform a technical feasibility and cost-benefit analysis of the smart thermostat controls.

Required skills

Strong communication skills, both verbal and writing, in English
Good understanding of building technical systems
Good programming (e.g., Matlab, Python or Excel) and data analysis skills
Previous experience with building energy and comfort simulation programs (e.g., IDA-ICE, TRNSYS)

Contacts and supervision

Jonas Wu

Industrial supervisor
Director, JLW
jonas@jlwf.se
+46707968313

Page responsible:Oxana Samoteeva
Belongs to: Energy Technology
Last changed: Nov 02, 2024
Sodium-Ion Batteries: Building the Foundation for a Greener Future via Life-Cycle Assessment and Techno-Economic modelling
Development of compact I-V curve tracer and load simulator for photovoltaic laboratory test rig
Development of remotely accessible battery laboratory exercise test rig
Experimental investigation of the flow dynamics in moving bed heat exchanger for powder particles
Experimental investigation of vertical electric heater for powder particles for CSP applications and energy storage
Investigation of usage of different methane fuel qualities for rocket engines with respect to the pyrolysis stability
CFD based design study of heat exchangers for high temperature heat pump applications.
Biogas production/storage for lessened dependency on oil
Refurbishment Strategy Based on Smart Radiator Controllers
Solar Photovoltaic-Thermal Integration with Ground Source Heat Pump Systems for Single-Family Houses
Integration of Solar Photovoltaic-Thermal (PVT) Collectors in District Heating Networks
Heat Propagation in High-Temperature Geothermal Wells
Experimental evaluation of advanced features of a modern heat pumping system
Energy use optimization of vertical farming systems
Rethinking Capacity Development in Energy Modeling: Integrating Local and Indigenous Knowledge Systems in Transboundary Contexts
Optimizing Waste Treatment Pathways for Sustainable District Heating Development: Integrating Material Flow and District Heating Models in OSeMOSYS
Evaluation of Direct and Indirect Methods for Occupancy Detection and Air Quality Control in Buildings
Data-driven Analysis of Building Energy Performance Using Boverket Energy Declarations and real-time data
Social Life-cycle impact assessment of innovative cascade PCM based thermal energy storage solutions
Water Demand Forecasting from Multipurpose Reservoirs in Cochabamba, Bolivia, to 2050: A Sustainable Energy Perspective
Electrification of the heating sector in Europe
Safe use of flammable refrigerants-literature review
Safe use of flammable refrigerants-Modeling concentrations of the leaked refrigerants in case of accidental emissions in different scenarios
Boiling inside rectangular microchannels: Investigating the use of high-speed IR camera for temperature readings
Characteristics and kinetic study on catalytic and non-catalytic pyrolysis of PVC and wind blades in molten salts via thermogravimetric analysis
Characterization of Phase Change Materials for a real Thermal Energy Storage Application
Predictive model control design for a small-scale steam engine based multi-source CHP system
Solar hydrogen production by photocatalytic reforming of cellulose with concentrated sunlight
Circularity of batteries
Kartläggning och Optimering av kyla på KTH Campus
Battery application in harbour environment
Empowering the Future: Innovating Sustainable Energy with Digital Heat Pump Solutions
Optimizing Energy Performance in Existing Urban Building Stocks: A Comprehensive Analysis and Strategic Approach for Sustainable Operation
Techno-economic and feasibility assessment for nuclear plants combination with CO2 sequestration and green fuels production units
Techno-economic and feasibility assessment for nuclear plants integration in flexible future energy systems for grid balancing and ancillary services
Analysis of Residual Resources
Life-cycle impact assessment of innovative cascade PCM based thermal energy storage solutions
Techno-economic assessment and optimization of seasonal thermal energy storage in district heating networks
Final Commissioning and Experimental Performance Characterization of a Bench-scale Thermochemical Heat Storage System (SEU/SPG)
Renewables and Demand Side Management
Circularity measurement for automotive industries
Experimental Investigation of Optimal Flow in Borehole Heat Exchanger at KTH Live-in Lab
Low Global Warming Potential Refrigerants for high temperature heat pumps
Development of battery test rig: Remote Battery Lab
Comparative analysis of thermal storage options for industrial steam generation in a solar thermal integrated system
Development, Implementation & Evaluation of an optimized operation algorithm for a Li-Ion battery Energy Management System (EMS) at Tezpur University
De-icing of trains in a Nordic climate
Calibration of a measurement system for methane pyrolysis detection in rocket nozzles
Experimental study on the effect of rocket nozzle wall materials on the stability of methane
Sanitary water flows for housing
Evaluating the potential of energy efficiency improvement in combined cycle power generation to minimize the CO2 footprint in the context of Sri Lanka
Smart and Sustainable Oskarshamn: Energy Management and urban system analysis
Aqueous ammonia in refrigeration applications
Photovoltaic system design, installation and performance evaluation: PV Lab test rig
Ground source heat pumps in densely populated areas - a techno-economic study
Replacement of old ground-source heat pumps – a techno-economic study
PV-ESS system optimization to maximize self-consumption of PV-generated in KTH live-in lab
Environmental assessment of SESS applications based on cradle to grave LCA
High and low temperature electrolysis integration in Combined Cycles
Novel solar technologies and SOEC integration for synthetic fuels
Digitalization of HVAC schema drawings
Development & implementation of an improved operation algorithm for a Li-Ion battery energy management system (EMS) at Tezpur University
Techno-economical analysis of large refrigeration systems - operational and maintenance strategies
Comparision of high fidelity and real-time CFD methods for simulating thermal comfort
Data driven heat pump models for generation of electrical load profiles at DSO level
Master thesis at Bosch Thermoteknik
Geospatial modelling in support to Energy Access in Putumayo Colombia
EPIC Africa CLEWs assessment supporting Burkina Faso’s development plans
Using machine learning to spatially classify current technologies used for cooking in developing countries
Accounting for affordability constrains in geospatial modelling of clean cooking access
Rethinking Capacity Development in Energy Modeling: Integrating Local and Indigenous Knowledge Systems in Transboundary Contexts
Optimizing Waste Treatment Pathways for Sustainable District Heating Development: Integrating Material Flow and District Heating Models in OSeMOSYS
Enhancing Socio-Economic Impact Assessment in Climate-Compatible and Self-Sufficient Rural Communities through Integrated Resource Optimization Models
Climate impact of renovation projects in the built environment– zooming in on technical installations